rs legacy conversion not starting
#1
Scooby Newbie
Thread Starter
Join Date: Jun 2013
Location: Perth
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
rs legacy conversion not starting
hi all, just looking for some expert advice my issue could be... ive done a whole loom swap from a 91 legacy that i wrecked and have swapped into another liberty. upon connecting everthing back up and putting a battery in the circuit the alternator clicked and a bit of smoke came out. i then also found i blew the big black wire fuse in the fuse box. all help would be appreciated asap cheers
#2
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
Common for UK models to be cut down cheaper versions with inferior specification....
Thus the loom may well be different.
Best of luck with that one.
dunx
Thus the loom may well be different.
Best of luck with that one.
dunx
#3
Scooby Newbie
Thread Starter
Join Date: Jun 2013
Location: Perth
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
ive gotten the car to turn over it just wont fire. unsure if its leads and coils as theyre all knew. wasnt the fuel relay or pump, all the fuses are good so im pretty stumped
ps it is jdm legacy wiring and motor
ps it is jdm legacy wiring and motor
Thread
Thread Starter
Forum
Replies
Last Post