Gauge pods on 97 cars
24 May 2002, 11:24 PM
#1
Scooby Regular
Thread Starter
Join Date: Mar 2002
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone successfully modified a 3 gauge pod that goes into the 98> models coin tray to fit a 97 car. I like the idea of having the pod and gauges in the centre and not on the pillar. I don't mind chopping the housing but would rather not chop up the dash. Any ideas or suggestions would be great. Has anyone already done this. Cheers all
Marc
Marc
27 May 2002, 01:20 PM
#2
Ive been looking into fitting gauges there as well, and found this supplier http://www.omori-na.com/catalog/acce...ccessories.htm, about half way down this page is a DIN sized plate for 3 gauges, Ive been quoted just over $40 inc shipping.
27 May 2002, 06:46 PM
#3
Scooby Regular
Join Date: Mar 2001
Location: Derbyshire
Posts: 4,496
Likes: 0
Received 0 Likes
on
0 Posts
Or you could always make your own like I did 
OK it's on a MY00 but should be able to do the same on a pre MY98
http://www.scoobynet.co.uk/bbs/threa...threadid=99708
OK it's on a MY00 but should be able to do the same on a pre MY98
http://www.scoobynet.co.uk/bbs/threa...threadid=99708
27 May 2002, 09:59 PM
#5
Scooby Regular
Join Date: Mar 2001
Location: Derbyshire
Posts: 4,496
Likes: 0
Received 0 Likes
on
0 Posts
I haven't blocked off mine. You can do, and then you get more pressure out of the side ones (apparantly). I never have it on that setting anyway, it's always on windscreen, or windscreen and floor.
Shouldn't be too hard to block them off with some more plasticard.
Shouldn't be too hard to block them off with some more plasticard.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM