GezP

iTrader: (23)

Evening all

I've just purchased some new corbeau seats that need underneath fixing (not side mounts).

Some advice please, I've been told Buddy Club rails are the best and it can be a nightmare making some custom parts and using my existing sliding mechanism.

What have you guys done? Is there any guides to removing seats?

It's a WRX hawkeye.

Cheers guys
Gez

alcazar

iTrader: (2)

REMOVING seats is easy: 4 bolts. lift them out.

If there are airbags, disconnect battery for 30 minutes BEFORE disconnecting airbags, and be sure to have a resistor ready to bridge the terminals, or the airbag light will go on.

GezP

iTrader: (23)

thanks, do you know anything about transferring the subframe/rails?

alcazar

iTrader: (2)

Not a thing, sorry. My 98 classic seats came out, 99/00 STi seats went in.

GezP

iTrader: (23)

Does anyone know the resistance needed for the seat airbag wire? Any clues where to get them?

Are they the same resistors needed as the steering wheel?

Thanks

vicks

iTrader: (1)

if they are the same as mt bugeye which i would have thought they willl be then you need these off ebay mate
Item number: 120526047295

GezP

iTrader: (23)

Cheers mate