UK to JDM
30 November 2010, 07:24 PM
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Oct 2010
Location: Stockton-On-Tees
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
UK to JDM
How hard would it be to swop all the heater equipment over to JDM climate control from my standard uk I realise the JDM is all electonically controlled where as the UK uses steel wires was thinking of changing it all and having a go at fitting the facelift dash at the same time maybe its easier if i change the entire wiring harness? any input on this appreciated
02 December 2010, 02:45 PM
#3
Jason,
It won't be easy. There are threads on NASIOC about this. When I swapped my JDM Dash for a flocked one I noticed that the AC sensor is in a different place to the UK version. You already know the electrical harness is different, this is connected to the main loom and the JDM dash clock are on it, so there is something else to consider.
And I still have a complete JDM dash for sale
Not for the faint hearted.
It won't be easy. There are threads on NASIOC about this. When I swapped my JDM Dash for a flocked one I noticed that the AC sensor is in a different place to the UK version. You already know the electrical harness is different, this is connected to the main loom and the JDM dash clock are on it, so there is something else to consider.
And I still have a complete JDM dash for sale
Not for the faint hearted.
02 December 2010, 03:06 PM
#4
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Oct 2010
Location: Stockton-On-Tees
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Ill have a search for that info, im still planning on doing this just ran out of money for now have got some of the bits am trying to make sure I have everything I would need then it will be my project next time im home for 5 weeks which will be the end of January. Assuming the weather isnt as it is now because I wont be doing it in that.
Thread
Thread Starter
Forum
Replies
Last Post