MY01 door panel
#1
I have an annoying rattle within the drivers door, does anyone know how to remove the drivers door panel ? There is a screw at the bottom of door arm rest and one inside the release aperture which I have removed, but now what! Does the panel simply 'pull off' ?
Any help / experience welcomed...
Cheers - Mash
Any help / experience welcomed...
Cheers - Mash
#2
Once you have removed the 2 screws from the release handle and at the bottom of where you grab to close the door, take out the window switch unit and disconnect from the wiring loom, if i remember right there is another screw underneath where the switch unit sits take this out and then gently pull the panel away from the door starting at the bottom (2 grommets bottom and 2 each side)when the panel is loose lift it over the 2 plastic clips at the top of the door.
I had the said little rattle that p*ssed me off something rotten, the way i cured it was to glue all the grommets (poppers)directly to the door then put the panel back on and no more rattle.
Zippy.
I had the said little rattle that p*ssed me off something rotten, the way i cured it was to glue all the grommets (poppers)directly to the door then put the panel back on and no more rattle.
Zippy.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM