Lamda Link
#1
Hi all
I have been trying to get some sort of reading on my Lamda Link module ever since I bought it about 6 months ago. I have never actually managed to get it to work, other than getting the power light on. I have a 95 WRX with loads of mods, I have followed the instructions that came with it, using two different earths (one to the chasis and the other to the enging block) a live and a signal.
I have been told by Branco to connect it straight to my ecu wiring, but I can't seem to find which pin it goes in on. I am suspecting that there is something up with my Lamba sensor, I have replaced it with a universal one still with no success.
Can anyone either tell me which pin it should go on at the ecu or another way of connecting it. Even though I used a universal sensor it was still putting out a voltage, does anyone know what voltages the sensor will pick up on.
Heres hoping
Many thanks
I have been trying to get some sort of reading on my Lamda Link module ever since I bought it about 6 months ago. I have never actually managed to get it to work, other than getting the power light on. I have a 95 WRX with loads of mods, I have followed the instructions that came with it, using two different earths (one to the chasis and the other to the enging block) a live and a signal.
I have been told by Branco to connect it straight to my ecu wiring, but I can't seem to find which pin it goes in on. I am suspecting that there is something up with my Lamba sensor, I have replaced it with a universal one still with no success.
Can anyone either tell me which pin it should go on at the ecu or another way of connecting it. Even though I used a universal sensor it was still putting out a voltage, does anyone know what voltages the sensor will pick up on.
Heres hoping
Many thanks
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM