Prodrive gear knob fitting
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Apr 2008
Location: West Cornwall
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Prodrive gear **** fitting
Very silly question, but I have just bought a Prodrive **** for my MY06 WRX and the "P" is pointing in the direction of the dash, if you see what I mean. It should be pointing nicely central. I don't know what to do with it. The "P" doesn't come off (yet anyway) and I have no tool to shift the whole thing round. If I muck about, it will end up scratched to bits. I would appreciate any advice for a new member. Thanks.
#2
Scooby Regular
iTrader: (1)
Join Date: Sep 2003
Location: gravesend, kent
Posts: 4,721
Likes: 0
Received 0 Likes
on
0 Posts
Very silly question, but I have just bought a Prodrive **** for my MY06 WRX and the "P" is pointing in the direction of the dash, if you see what I mean. It should be pointing nicely central. I don't know what to do with it. The "P" doesn't come off (yet anyway) and I have no tool to shift the whole thing round. If I muck about, it will end up scratched to bits. I would appreciate any advice for a new member. Thanks.
can't for the life of me remember if there's a hole up the middle so you could pop off the 'P', if not it's only a sticky backed thing, i used a small scalpel blade to prise mine off and get it straight
Last edited by hoskib; 14 April 2008 at 08:46 PM.
#3
Scooby Regular
iTrader: (7)
Join Date: Aug 2002
Location: Lancashire & District Subaru
Posts: 2,989
Likes: 0
Received 0 Likes
on
0 Posts
Don't bother risking the sticker.
Just pop a small washer down the threaded hole & retighten - The "P" will end up in a different position then.
Add or remove washers until the "P" ends up where you want it
Just pop a small washer down the threaded hole & retighten - The "P" will end up in a different position then.
Add or remove washers until the "P" ends up where you want it
#4
just get a stanley knife blade flick the p off tighten the gear **** then stick it back on just done mine today cant tell its been off. cant see the point of sticking washers down the hole.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM