boost gauge
#1
i fitted a boost gauge from blitz standard size into the ashtray apature on my MY97 fitted remarkably easy too and looks as if it was there from the factory, if you want me to snd a photo e mail me ...
#2
I fitted my gauge into a pod mounted on top of the dash next to the driver's side pillar. I don't see much use in a boost gauge that you can't _safely_ monitor whilst actually driving the car.
Moray
Moray
#3
Rob,
Nice one. Personally I removed the ashtray/lighter and built a double-height fascia with my guage mounted. GGR supplied the guage. I am going to rework as the MY94 WRX uses a slightly 'proud' fascia and mine is not fully flush.
All this for a dial you can't even look at when driving! Hehe!
Nice one. Personally I removed the ashtray/lighter and built a double-height fascia with my guage mounted. GGR supplied the guage. I am going to rework as the MY94 WRX uses a slightly 'proud' fascia and mine is not fully flush.
All this for a dial you can't even look at when driving! Hehe!
#4
Agree with Moray...helps if you can actually look at the gauge safely while driving!
I fitted the Subaru column mount gauge, looks really good as it matched exactly the cars dials...nice illumination as well. Available from GGR (if you have loads of money to spend!) got mine from a mate.
[This message has been edited by Spikey (edited 18-04-2000).]
I fitted the Subaru column mount gauge, looks really good as it matched exactly the cars dials...nice illumination as well. Available from GGR (if you have loads of money to spend!) got mine from a mate.
[This message has been edited by Spikey (edited 18-04-2000).]
#5
I fiited my boost gauge in the drivers side vent - veryeasy to see and the air vent still works (not quite as good as before but still effective (and keeps gauge cool )
Paul
PS - Picture was before vent was reseated properly and I don't get reflections normally
[This message has been edited by pnebbs (edited 18-04-2000).]
Paul
PS - Picture was before vent was reseated properly and I don't get reflections normally
[This message has been edited by pnebbs (edited 18-04-2000).]
#6
We now have access to a DIN sized mounting frame which will take 3 x 45mm 0r 52mm gauges, each one of which is angled towards the driver. That's for those who don't want the top centre gauge console.
There are 3 seperate designs. Pictures & prices will be on our web site Soon.
Mike.
There are 3 seperate designs. Pictures & prices will be on our web site Soon.
Mike.
Thread
Thread Starter
Forum
Replies
Last Post