How do I remove a Nardi wheel, replace with a Momo?
I have a MY95 with the standard non-airbag Nardi wheel and have a non-airbag Momo and boss adaptor.. how do I swap them?
anyone after a Nardi wheel in average condition (50k miles), when i manage to change it for the new one...
anyone after a Nardi wheel in average condition (50k miles), when i manage to change it for the new one...
I just changed my Nardi wheel for a momo one on a MY93 WRX (don't know if yours is the same) it was a 10 min job just prise off the horn push cover and you can see the 8 allen bolts in the center remove these then screw the momo wheel in it's place (no need for boss adaptor) then little faf about with the horn push and Bobs your mothers brother
hope your is as simple
Ali G
hope your is as simple
Ali G
Trending Topics
iirc dont pull the horn out,dont try putting an allen key in allen key slots either
the silver stuff on the wheel will just peel off like an orange
grab it above the horn and pull..........gently
the stuff is very pliable,disconnect the horn,i think its a 19 mm socket holding the wheel in,un do it a little(not the whole way)
give the wheel a pull,tap from behind and hopefully youll have a steering wheel and boss in both hands and your front teeth still in your mouth
the silver stuff on the wheel will just peel off like an orange
grab it above the horn and pull..........gently
the stuff is very pliable,disconnect the horn,i think its a 19 mm socket holding the wheel in,un do it a little(not the whole way)
give the wheel a pull,tap from behind and hopefully youll have a steering wheel and boss in both hands and your front teeth still in your mouth
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
34
Nov 7, 2024 04:10 PM



