How to cut the holes
#1
Am I missing something here?? 52mm gauges surely means the diameter of the gauge housing, not the facia and bezel I cut all my hols to 52mm and they fit perfectly first time ...
Also, you'll need to have sufficient space between the holes to get the bezels in.
Edited to add 'Also...'
[Edited by mook - 9/6/2002 6:32:44 PM]
Also, you'll need to have sufficient space between the holes to get the bezels in.
Edited to add 'Also...'
[Edited by mook - 9/6/2002 6:32:44 PM]
Trending Topics
#9
Did mine with a 50 mm hole saw to fit 52mm Defi's. Tiny bit of filing needed with a half-round file afterwards to get everything perfect.
Word of caution if you've not used a hole saw before - go very light with the pressure on the drill, use a low drill speed and make sure that someone's holding the pod down. Lots of teeth = lots of grip = SM pod doing a 180 on the workbench in my case. That'll learn me!
Word of caution if you've not used a hole saw before - go very light with the pressure on the drill, use a low drill speed and make sure that someone's holding the pod down. Lots of teeth = lots of grip = SM pod doing a 180 on the workbench in my case. That'll learn me!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM