NEILB1

iTrader: (9)

Its a newage so the alarm used to go of when i tryed to start it without disarming it i.e if i went into a shop and came back out i have to turn the ignition on and disarm now nothing, no siren

I know it works as i have heard it before

Also should it beep or something when i arm the car, the hazard flash nut no noise ?

arrr **** just noticed it is in the wrong section now

Neanderthal

iTrader: (6)

Strange, mine has never made a noise (MY03).
I think it's in the options for the alarm. Pull down the little door where the fuses are and input the code to enable it.

NEILB1

iTrader: (9)

what will that enable the noise, THE remote all works fine fella, JUST WONDERING if it should been when arming and disarming ?

Mikey Ace

iTrader: (1)

on my GT Auto alarm, the not beeping on arm/disarm happens when the backup battery in the main unit is low or defunct. maybe the same in the on eyou have?

Mikey

joey_turbo

iTrader: (26)

If its a standard Sigma alarm, try this:

Adjusting Door Open Warning Bleep Volume (Option *on the keypad)
To switch between loud and soft door open warning bleeps, turn on the vehicle s ignition,
type *on the keypad and immediately turn off the ignition.

NEILB1

iTrader: (9)

all that works, but it used to alarm sound when i turned the ignition on when it was imobilised

mrmarc

iTrader: (6)

Neil,
ive recently had a problem with my alarm and it turns out there is a 9v battery in the siren box that could be at fault.

its only a 10-15min job to swop it over..
could be worth a bash.


EDIT.

should have asked...does the alarm sound at all now?..as in if you set it off?

NEILB1

iTrader: (9)

yes it will sounds fella, LOOKED through the alarm info and it does look as if it is not sopposed to sound on activeation and disarm