59 plates how do i get it out
#1
Scooby Regular
Thread Starter
59 plates how do i get it out
Guys anybody tell me how i take out the double dun headunit from a new WRX-S, cant see anything obvious.
Also if i buy the top end kenwood or JVC what will i need at the back to connect it ?
an ISO convertor ? anything else ? faceplate or such or is it rip and replace
thanks in advance
Also if i buy the top end kenwood or JVC what will i need at the back to connect it ?
an ISO convertor ? anything else ? faceplate or such or is it rip and replace
thanks in advance
#2
Pretty sure it will be the same as the STI, if so to remove it's just a matter of pulling off the plastic surround panel, hook your nails under the bottom & pull, just clips in
Head unit on ours is located by 4 screws, obvious where they are when the panel is removed
Our head unit was changed for a Kenwood when new by Litchfields, I know they deal with Bass Junkies Car Audio Equipment - BassJunkies.com there is another unit you need to use the steering wheel controls, needs a couple of wires soldering but nothing major. Bass Junkies should be able to advise
Head unit on ours is located by 4 screws, obvious where they are when the panel is removed
Our head unit was changed for a Kenwood when new by Litchfields, I know they deal with Bass Junkies Car Audio Equipment - BassJunkies.com there is another unit you need to use the steering wheel controls, needs a couple of wires soldering but nothing major. Bass Junkies should be able to advise
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM