Quick question
#1
This may sound daft but....
I fitted my CD autochanger this weekend (thanks for all the advice guys) but I lost my bottle when I was about to screw the autochanger to the floor.
Is it best practice to screw through the floorpan ? Will it leak ? Will it affect the bodyshell warranty?
Thanks
Mike
PS Scooby owners really are a friendly bunch - went down to Halfords to do the fitting (in case I needed to procure some obscure grommet at quick notice) and was quickly surrounded by a couple of scooby owners who work there offering advice and a bit of mutual (car!) admiration!
I fitted my CD autochanger this weekend (thanks for all the advice guys) but I lost my bottle when I was about to screw the autochanger to the floor.
Is it best practice to screw through the floorpan ? Will it leak ? Will it affect the bodyshell warranty?
Thanks
Mike
PS Scooby owners really are a friendly bunch - went down to Halfords to do the fitting (in case I needed to procure some obscure grommet at quick notice) and was quickly surrounded by a couple of scooby owners who work there offering advice and a bit of mutual (car!) admiration!
#2
Try getting stick on Velcro from somewhere like John Lewis Haberdashery. It comes in various widths and lengths.
I used it to stick down the carpets in my old Elise. Worked better than the stuff that came with the carpets.
Minus side is cost - could be upto 10 squid
I used it to stick down the carpets in my old Elise. Worked better than the stuff that came with the carpets.
Minus side is cost - could be upto 10 squid
#3
Hi Mike,
Two possible downsides to using velcro:
1) The CD changer may skip more than if it was bolted/screwed down.
2) It's really easy for any tea leaves to remove if they break into your car.
I guess the plus side is that they probably won't do any damage to the car when trying to get it out :O
One possible solution is to put the changer under the passenger seat. I did this with my previous Scooby, as I wasn't happy drilling holes in the boot area given the close proximity of the fuel tank.
In the end, I made a thin MDF baseboard which I secured using some brackets that were held in place by the seat mounting bolts. I then bolted the CD changer to the baseboard. No holes in the bodywork, and a rock solid base for the changer to rest on.
Whether or not you can do this will depend on how high your changer is.
Andy.
Two possible downsides to using velcro:
1) The CD changer may skip more than if it was bolted/screwed down.
2) It's really easy for any tea leaves to remove if they break into your car.
I guess the plus side is that they probably won't do any damage to the car when trying to get it out :O
One possible solution is to put the changer under the passenger seat. I did this with my previous Scooby, as I wasn't happy drilling holes in the boot area given the close proximity of the fuel tank.
In the end, I made a thin MDF baseboard which I secured using some brackets that were held in place by the seat mounting bolts. I then bolted the CD changer to the baseboard. No holes in the bodywork, and a rock solid base for the changer to rest on.
Whether or not you can do this will depend on how high your changer is.
Andy.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM