jiffthejiffmanjaffa

iTrader: (10)

Hi all,

I'm in the middle of doing up my car stereo system and I've come up with a good way of using my stereo's full capabilities as a graphic equaliser.

But, and there's always a but... I have a F4-240 amp with two RCA inputs. Which previously I used for front and rear settings.

Now I have another Amp, which I was going to connect the Front RC out and then connect the rear RCA out to the F4 amp.

Thing is I don't know the right setting for the Amp wot work where all four channels run on one RCA feed. I know it can be done, as I've previous had it set up like this. But wally here lost the manual.

Before I went trial and error route, which I know will take me ages, I wondered if anyone has such an amp and knows the answer or better yest has a manual for one and can send it to me or scan it and E-mail it.

Anything to be fair would be better than laying down in the boot for a good few hours.

jiffthejiffmanjaffa

iTrader: (10)

Problemd, took me less than 15mins in the end, ha ha ha.

It only took the push of one little button. If only all problems were that easy to fix!!!!