amp wiring, where to go through the bulkhead
#1
amp wiring, where to go through the bulkhead
im just installing an amp wiring kit in my v4 sti, ive routed the wires from the boot into the passenger side foot well but cant find where to go through the bulkhead, has anyone done one and got any idea where to go through? any advise would be great
cheers
cheers
#2
I`ve just installed a wiring kit in my 04 WR1 & took the glove box out which made life a lot easier to see what I was doing! It`s easy to remove with only a few screws to take out!
The easiest way through the bulkhead was through the large rubber gromet where the a/c comes into the car. I pierced a hole in the grommet with a screwdriver ( carefully!!) from the engine side then fed the live cable through into the car.
Hope this helps!
The easiest way through the bulkhead was through the large rubber gromet where the a/c comes into the car. I pierced a hole in the grommet with a screwdriver ( carefully!!) from the engine side then fed the live cable through into the car.
Hope this helps!
#3
Scooby Senior
Join Date: Feb 2003
Location: West Midlands
Posts: 1,903
Likes: 0
Received 0 Likes
on
0 Posts
#5
thanx for that, ive found the air con pipe but wasnt sure wheter to route it through there or not, and ill take out the glove box make life a bit easier, thanx again
#7
Hey fellas, there's sorta 2 sides to the bung and its about an inch thick, and I found it a bit difficult to know whether I'd made it all the way through. So I got a long (8"), thin, flatbladed screwdriver, wrapped the wire around the balde and made a small knot on the shaft behind the head (ooo err), pushed that through and was easily able to find the driver / wire. That way I didn't end up making a massive hole in the bung that could let water or fumes through.
Thread
Thread Starter
Forum
Replies
Last Post