Whats the best way to get the power to my amp in my boot? I have wired the thing all the way to the passenger footwell but was looking for advice on the best place/ where to drill etc.... to get the wire to the battery???

oh yeah,, its a 95 Import WRX Wagon!

 

Connect a suitable gauge power cable direct to the battery & feed it through the large rubber grommet in the bulkhead (air-con pipe). Then you should be get hold of the cable from the passenger side footwell area. Remove the plastic side sill trims & lift up the carpet. Feed the cable along until you reach the boot. No need for drilling.
I would be careful drilling in the boot as the petrol tank sits under half the seat area & boot.

I have mounted the amps to the back of the seats. Earth cable is bolted to the seats belt bracket.
Phono cables are routed on the drivers side & centre.

Ticky

 

Just needed the best way to get from the footwell to the bonet area... Ive already done the rest of the wiring!!

Thanks alot for that! I will have a look tomorrow! Is it easy to find this pipe???

 

Yes it is mate... just look up in the passenger footwell, and feel around... u will eventually feel the gromit in the bulkhead which you need to go through.

 

Is there just one gromit in the footwell or is there another in the engine bay as well????

 

The grommit is behind the blower motor unit/aircon. Its kind of level with the lower glove box handle. Hence having to feel around. Its better to push the cable through the grommet from the engine bay first. Then try to find it from inside the car.

 

Thanks mate, I will try that tomorrow!! I think I know the one your on about... Does it have a pipe comming off it and bending at 90 degrees???