Hi guys,

I have a 2004 Subaru Impreza STi and I'm trying to install a keyless entry unit, because my old one doesn't work. I followed the wiring instructions(see below) but the unit is not locking the car...
Also I have attached the manual for my new unit. Can someone give me instructions which wire I need to connect where, maybe I did something wrong....

Thank you


12volts white + ignition harness
Starter white/black + ignition harness
Second Starter N/A
Ignition green + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory yellow + ignition harness
Second Accessory N/A
Keysense white/red + ignition harness
Power Lock red/white - gray plug at integrated module
Notes: The integrated module is to the left of the steering column.
Power Unlock yellow/red - gray plug at integrated module
Notes: The integrated module is to the left of the steering column.
Lock Motor orange 5wi blue plug at integrated module
Notes: The integrated module is to the left of the steering column.
Unlock Motor red 5wi blue plug at integrated module
Notes: The integrated module is to the left of the steering column.
Parking Lights+ black/red or orange + parking switch
Parking Lights- black/white - lighting switch
Notes: The negative parking lights wire only works with the ignition on.
Hazards same as turn signal wires
Turn Signal(L) black/green + steering column
Turn Signal(R) lt. green/black + steering column
Reverse Light brown/yellow + passenger kick, harness to rear
Door Trigger yellow - gray plug at integrated module
Notes: The integrated module is to the left of the steering column.
Dome Supervision blue - blue plug at integrated module
Notes: The integrated module is to the left of the steering column.
Trunk/Hatch Pin yellow/red - keyless entry control module
Notes: The keyless entry control module is above the driver kick panel.
Hood Pin N/A
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm factory remote only
Factory Alarm Disarm factory remote only
Disarm No Unlock factory remote only
Tachometer green ac ECM below glove box
Notes: On the non-turbo models the tach is in pin 10 of the 35 pin plug. On the turbo models the tach is in pin 9 of the 24 pin plug. On the STi models the tach is in pin 23 of the 34 pin plug.