radiator / header tank plumbing
#1
Scooby Regular
Thread Starter
Join Date: Mar 2013
Location: Horsham
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
radiator / header tank plumbing
just plumbing in my custom rad for my WRX/ escort project,.
and just want to double check piping , there are two pipes coming from the small header tank , lower one goes into top of rad ( as a air bleed i guess for filling )
and the 2nd one is on the cap neck , assume this is just a blow off/ over pressure release , so just drains down a pipe to ground somewhere ? or is it normally plugged into somewhere ?
i knew i should have taken more photos
ps , yes its tight ,and rad is not in its final position , it will be moving forward .. but still ... not by much
Matt
and just want to double check piping , there are two pipes coming from the small header tank , lower one goes into top of rad ( as a air bleed i guess for filling )
and the 2nd one is on the cap neck , assume this is just a blow off/ over pressure release , so just drains down a pipe to ground somewhere ? or is it normally plugged into somewhere ?
i knew i should have taken more photos
ps , yes its tight ,and rad is not in its final position , it will be moving forward .. but still ... not by much
Matt
Last edited by 16vmini; 12 June 2013 at 10:01 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM