Hi everyone,

Removed my inlet manifold yesterday to replace the main intake hose which was on its last legs, also stuck a set of STi injectors in too ready to be mapped Wednesday.

Built most of it all back up and connected the battery and guess what, fuel spraying out the inectors, so obviously werent seated right, strip it all down again, one of the o-rings looked a little worn so swapped that from my old injector, the other side needed the pressure seal swapping as it looked warped.

Can't see any leaks now which is good, but im struggling with the routing of the breather hoses from the heads to the metal pipes conencted the intercooler,

Does anyone have any pics as im going to finish this off later.

Thanks