snapped a/c tensioner mount - help
28 August 2012, 03:45 PM
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Jun 2010
Posts: 680
Likes: 0
Received 0 Likes
on
0 Posts
snapped a/c tensioner mount - help
Hi guys,
I have a bit of a problem, the rod that goes through one of the a/c pulleys has snapped.
Is it as simple as sourcing a new pulley with the mount on and bolting it back in?
Can i simply remove the tensioning setup and run the car without an a/c belt until I can get it fixed? Pic...
I have a bit of a problem, the rod that goes through one of the a/c pulleys has snapped.
Is it as simple as sourcing a new pulley with the mount on and bolting it back in?
Can i simply remove the tensioning setup and run the car without an a/c belt until I can get it fixed? Pic...
28 August 2012, 03:52 PM
#4
Scooby Regular
iTrader: (6)
Join Date: Feb 2010
Location: north of the south border
Posts: 4,510
Likes: 0
Received 0 Likes
on
0 Posts
undo the bottom nut and tension the belt with a lever then tighten up the nut and it will be fine fella, replacments are about £15 so not too bad,.
Thread
Thread Starter
Forum
Replies
Last Post
supshon
General Technical
2
03 October 2015 08:06 PM