anyone experienced stupidly tight cambelt pully bolts?
#2
Scooby Regular
Join Date: Nov 2006
Location: Enginetuner.co.uk Plymouth Dyno Dynamics RR Engine machining and building EcuTek SimTek mapping
Posts: 3,662
Likes: 0
Received 0 Likes
on
0 Posts
i was removing them today, went to the 1st one with a half inch air gun and undone no problems
went to the next but wouldnt undo? so tried the other 2 and they were proper tight to!!
resulted in a half inch big breaker bar on the bolt with a length of gas pipe as leverage with a spanner on the hex part of the camshaft with a scaffold bar as leverage
i was shocked as NEVER have i seen cam pully bolts this tight!
went to the next but wouldnt undo? so tried the other 2 and they were proper tight to!!
resulted in a half inch big breaker bar on the bolt with a length of gas pipe as leverage with a spanner on the hex part of the camshaft with a scaffold bar as leverage
i was shocked as NEVER have i seen cam pully bolts this tight!
Thread
Thread Starter
Forum
Replies
Last Post