ECUTEK gear position question...
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Apr 2006
Location: Stoke On Where?
Posts: 764
Likes: 0
Received 0 Likes
on
0 Posts
ECUTEK gear position question...
Just started to have a play with the dash delta software, and noticed that I seem to have an issue with the gear position.
Now the software recognises my car as a 2003 JDM spec C, which is slightly unusal, as far as i`m aware my car is just a 2003 JDM.
But anyway, I was looking through the live data loging, just getting used to the software, and noticed that (Gear Position Spec C) was reading as being in sixth when in neautral, and when any gear is selected, it reads as being in first.
Is this likely to be another NPS issue, been through 2 in 10000 miles!
Now the software recognises my car as a 2003 JDM spec C, which is slightly unusal, as far as i`m aware my car is just a 2003 JDM.
But anyway, I was looking through the live data loging, just getting used to the software, and noticed that (Gear Position Spec C) was reading as being in sixth when in neautral, and when any gear is selected, it reads as being in first.
Is this likely to be another NPS issue, been through 2 in 10000 miles!
Last edited by Bicco; 29 December 2011 at 09:47 AM.
#2
Scooby Regular
Don't worry about it mate... the gear position doesn't work!
The fact that Delta Dash thinks your car is a MY03 Spec C is just that your ECU has the MegaROM code on it. Again no need to worry as this is fine.
The fact that Delta Dash thinks your car is a MY03 Spec C is just that your ECU has the MegaROM code on it. Again no need to worry as this is fine.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM