Hi folks,
I'm rebuilding my 2.35 stroker at the moment.
My block was bored to 98mm for Wiseco stroker pistons (K602M98*) - now one bore is slightly damaged and I just wanted to ask if somebody has already rebored his EJ22 CDB to more than 98mm.
If so which pistons were used?
As far as I'm aware there is no bigger oversize available from Wiseco.

I hope I can rebore it again without loosing too much strengh of the block.

I already saw that there are sleeves available for EJ22 blocks - maybe somebody has tried this route before?

Thanks,
Rudi

 

up

 

Doubt if you will get 98mm+ pistons 'off the shelf' without having them custom made Rudi - You might be better off sleeving the crankcase's and going back to 97.50mm Stroker pistons.

Mick