i have been offerd a vf35 turbo i have a 93 wrx running a td05 with a 90 degree bend on it what would i need to get it to fit ??

any help would be apreciated

 

It will bolt on,but you may need a samco 90 degree snorkel pipe to get it to fit to your oe inlet pipe,which is easier than fitting a inlet pipe under the inlet manifoldand re routing your maf,air filter ,etc. Dont forget car will need a remap as ecu will fuel for a td05

 

thanks midnigt where the besst place to find the snorkel pipe ? i have found a site that sells spacer plates for the inlet manifold would i be able to fit a 96 intake pipe on if i went don this route??

 

I am not to sure of the diameter of your turbo compressor outlet pipe but if you were to measure it and buy something like this ,it should work :

http://www.ebay.co.uk/itm/Samco-90-D...item5adc2b9e82

Faling that you could opt for this :

http://www.ebay.co.uk/itm/SAMCO-SILI...item3f0e111da0