Nikrace

Hi everyone,
I want to diagnose my abs system,because it has a fault.(abs lights on after the first 100metres).i found a possible abs connector which is a Grey 14 pin connector with 2 black/red striped wires hanging next to it.is it possible to Diagnose this system without a scan tool through flashing codes ?is it possibly diagnosed via the obd plug and i cant do anything without a scan tool?
the car is spec-c sti 2005.
any help would be more than apprecieated.
Thanks in advance and sorry for my average English.

kennyc

iTrader: (1)

try this to pull up flashing lights with errors on ABS/DCCD.

"There is a 'procedure' that allows the DCCD position indicators to blink out a trouble code pattern.

Here is the procedure from the 2007 Impreza service manual.....

1. WHEN USING THE DIAGNOSIS INDICATOR LIGHT NOTE:
Perform steps 4) to 8) below within 30 seconds.

1) Securely apply the parking brake.
2) Switch the center differential control dial in the
differential free position.
3) Start the engine.
4) Switch the center differential control dial in the
differential lock position.
5) Release the parking brake.
6) Switch the center differential control dial in the
differential free position.
7) Securely apply the parking brake.
8) Repeat steps 4) to 7) two more times."

Nikrace

thank you Kennyc i will try it.