"oil temp sender, blanking plug WHERE!!"
#1
Scooby Regular
Thread Starter
Join Date: Sep 2010
Location: wild and sunny west wales
Posts: 482
Likes: 0
Received 0 Likes
on
0 Posts
"oil temp sender, blanking plug WHERE!!"
Hi, I have got a GB270, I am in trying to fit some defi gauges, I have done the oil pressure, under alternator, boost, in pipe near dv, both work fine. I have removed my TMIC, but cannot see/ find the blanking plug over the 3rd cyl. To fit the temp sender, Please can someone put up a photo, give directions of where the plug is, thank rob
#3
Scooby Regular
iTrader: (2)
It's actually quite hard to see, the plug is the same colour as the engine block and both are probaly covered with a layer of the same coloured grease/muck.
It's around 20-25mm diameter, flat, with an 8mm hexagonal hole in the centre. To remove it, you need a LONG decent 8mm Allen key/hex wrench.
It's around 20-25mm diameter, flat, with an 8mm hexagonal hole in the centre. To remove it, you need a LONG decent 8mm Allen key/hex wrench.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM