clutch question plz
#1
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: Glasgow, Scotland
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
clutch question plz
hi guys just pulled gearbox out of my subaru classic my96 wrx import
wanted to put it back but was unsure if release bearing goes on the flywheel first or clipped on the pressure plate first if on pressure plate first how do u guide the fork back in without messing it up
wanted to put it back but was unsure if release bearing goes on the flywheel first or clipped on the pressure plate first if on pressure plate first how do u guide the fork back in without messing it up
#3
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: Glasgow, Scotland
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
i take it the clip and the other bit go on the pressure plate then the bearing pushes in that way
i was trying with the old one to push the clip and the ring with the bearing on it threw the plate did not think that was right
i was trying with the old one to push the clip and the ring with the bearing on it threw the plate did not think that was right
#4
Scooby Regular
iTrader: (15)
Join Date: Jul 2009
Location: Somewhere halfway between heaven and hell, some call it earth!
Posts: 1,305
Likes: 0
Received 0 Likes
on
0 Posts
Yep, just put on the forks then when the gearbox is back on just push the fork back and the bearing will clip in and hold
It's a pull type clutch which if your used to doing push types all the time, does seem confusing at first
It's a pull type clutch which if your used to doing push types all the time, does seem confusing at first
Last edited by TH3_5T1G; 31 August 2011 at 10:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM