Turbo Vac Hose (from actuator)
03 July 2011, 01:07 PM
#1
Scooby Newbie
Thread Starter
Join Date: Jul 2011
Location: Tamworth
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Turbo Vac Hose (from actuator)
Hi all
Ive had my car for a few weeks now and it kept boosting rather aggressively and then the engine management light would come on.
on deeper inspection i found one of the hoses had a screw inside it (picture attached)
now this would have needed to have been forced in as it wouldn't get in there n its own !!!!
i take it this screw is not suposed to be in this hose !!!!
Regards
Neo
Ive had my car for a few weeks now and it kept boosting rather aggressively and then the engine management light would come on.
on deeper inspection i found one of the hoses had a screw inside it (picture attached)
now this would have needed to have been forced in as it wouldn't get in there n its own !!!!
i take it this screw is not suposed to be in this hose !!!!
Regards
Neo
03 July 2011, 01:07 PM
#2
Scooby Newbie
Thread Starter
Join Date: Jul 2011
Location: Tamworth
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
if you look above also i have lined the screw up as it was in the hose and the bulge can be clearly seen !!! (also car is a 2004 WRX on a 54 plate)
Last edited by NeoFuture; 03 July 2011 at 01:09 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
jobegold@hotmail.co.uk
ScoobyNet General
2
27 September 2015 09:44 PM
