Fitting Decat down pipe
#1
Scooby Regular
Thread Starter
Join Date: Dec 2010
Location: St.Helens
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Fitting Decat down pipe
how do i fit a decat downpipe to my 95 wrx and is it difficult? and im likely to snap any bolts and generally f*** it up?
#2
Scooby Regular
iTrader: (1)
Join Date: Aug 2010
Location: Worthing
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
undo bolts on turbo end but leave in till all other bolts are undone or will fall on your head lol and that hurts hehe and then disconnect the 02 and cat on fire sensors.
jack it up and get under the car the the cat part on the dp, should be a bracket, undo this and then undo bolts for mid section and lower,
job done
putting decat on is same, easy but you need to block of the hole (if it has one) for cat on fire thing..
this is what i needed to do for my 98 sti,
have u had a remap, wouldnt recommend decat dp without one.
ps i would get new bolts and gaskets for piece of mind
jack it up and get under the car the the cat part on the dp, should be a bracket, undo this and then undo bolts for mid section and lower,
job done
putting decat on is same, easy but you need to block of the hole (if it has one) for cat on fire thing..
this is what i needed to do for my 98 sti,
have u had a remap, wouldnt recommend decat dp without one.
ps i would get new bolts and gaskets for piece of mind
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM