first start after rebuild
09 March 2011, 06:03 PM
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Apr 2008
Location: Milton keynes
Posts: 626
Likes: 0
Received 0 Likes
on
0 Posts
first start after rebuild
any advise on the first start after a rebuild i no i have to fill the filter up with oil but just wondering what the best way to prime the engine so i dont cause any damage..what i need to remove ect any adice would be much appriciated
09 March 2011, 06:12 PM
#2
Scooby Regular
iTrader: (3)
Join Date: Apr 2005
Location: south wales
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
HI dooby-do.
take spark plugs out and disconect crank sensor. turn over till oil light goes out. , then plugs back in and sensor, and fire her up.
hope this helps cheers scoobymike
take spark plugs out and disconect crank sensor. turn over till oil light goes out. , then plugs back in and sensor, and fire her up.
hope this helps cheers scoobymike
09 March 2011, 06:21 PM
#3
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Apr 2008
Location: Milton keynes
Posts: 626
Likes: 0
Received 0 Likes
on
0 Posts
when u say oil light i take it you mean the oil light on the dash i wont be fireing it up until next week as waiting for oil pressure gauge and few other bits
.
Thread
Thread Starter
Forum
Replies
Last Post
toyney83
General Technical
10
02 October 2015 08:38 PM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM