just swapped td04 for vf30 - got problems
#1
just swapped td04 for vf30 - got problems
hi guys, so this afternnon i swapped out my td04 for a vf 30 on my 99 uk t plate classic, few little niggles here and there like someone had already misplaced the stud nuts for the turbo so its got two bolts and one nut holding the turbo on. what thread are these ?
next the guy who i bought the vf30 from had removed the bit which connects the wastegate spring pipe to the intercooler inlet pipe missing. where can i get one of these ?
was going to ring remappers in morning, been on a test run and up to shop, only about 3 miles and its already overheating, lost quite a bit of coolant when swapping turbo over so i topped back up , is there any need for bleeding it ? so i turned it off for the night. is it overheating because it needs a remap ? should i be worried ?
help please
next the guy who i bought the vf30 from had removed the bit which connects the wastegate spring pipe to the intercooler inlet pipe missing. where can i get one of these ?
was going to ring remappers in morning, been on a test run and up to shop, only about 3 miles and its already overheating, lost quite a bit of coolant when swapping turbo over so i topped back up , is there any need for bleeding it ? so i turned it off for the night. is it overheating because it needs a remap ? should i be worried ?
help please
#3
hi guys, so this afternnon i swapped out my td04 for a vf 30 on my 99 uk t plate classic, few little niggles here and there like someone had already misplaced the stud nuts for the turbo so its got two bolts and one nut holding the turbo on. what thread are these ? M10 x 1.25
next the guy who i bought the vf30 from had removed the bit which connects the wastegate spring pipe to the intercooler inlet pipe missing. where can i get one of these ? its 1/8 bsp to 8mm 90 deg from rswww.com
was going to ring remappers in morning, been on a test run and up to shop, only about 3 miles and its already overheating, lost quite a bit of coolant when swapping turbo over so i topped back up , is there any need for bleeding it ? so i turned it off for the night. is it overheating because it needs a remap ? should i be worried ? topped header tank up
help please
next the guy who i bought the vf30 from had removed the bit which connects the wastegate spring pipe to the intercooler inlet pipe missing. where can i get one of these ? its 1/8 bsp to 8mm 90 deg from rswww.com
was going to ring remappers in morning, been on a test run and up to shop, only about 3 miles and its already overheating, lost quite a bit of coolant when swapping turbo over so i topped back up , is there any need for bleeding it ? so i turned it off for the night. is it overheating because it needs a remap ? should i be worried ? topped header tank up
help please
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM
hedgecutter
General Technical
3
25 September 2015 02:35 PM