turbo running on spring pressure ?
#1
Scooby Newbie
Thread Starter
Join Date: Nov 2009
Location: Offshore most the time
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
turbo running on spring pressure ?
Car is running fine with no issues-
but the turbo is only working on spring pressure. 1 bar@3500-4000rpm then 0.8 bar 5000-7500rpm
Any ideas before it goes to the garage?
but the turbo is only working on spring pressure. 1 bar@3500-4000rpm then 0.8 bar 5000-7500rpm
Any ideas before it goes to the garage?
#4
Scooby Newbie
Thread Starter
Join Date: Nov 2009
Location: Offshore most the time
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
The car is an 02 sti ppp. The only mods are tubular manifold, no cat, ecutek, 20g, 3" nur spec. When the car was mapped last time it would not budge beyond 1 bar. the car made 320bhp but the torque was down to 220nm. In other words my clutch is having an easy time at the moment.
The only other thing is when i release the excellerator i get compressor stall before the blow off valve gets chance to work!!!
The only other thing is when i release the excellerator i get compressor stall before the blow off valve gets chance to work!!!
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM