chris_wrx

iTrader: (4)

what is needed for the conversion ?

i know you need box, diff, prop, cradle and starter but what about drive shafts and hubs?

im lost with all this talk of male female stub axles and other s#1t i dont understand cause it changes from 05 onwards

some one help

banny sti

iTrader: (68)

You will need the stub shafts from an earlier 6 speed box and fit them to the 06 box, so you can reuse your front drive shafts.



You can can get all the bits needed from dealers

dunx

iTrader: (3)

And oil seals

dunx

chris_wrx

iTrader: (4)

Can i not use the doner cars shafts?

T4YLOR 83

iTrader: (2)

Yes you can use all the driveshafts that match the diff and box and they will go straight into your hubs :-)

banny sti

iTrader: (68)

chris_wrx

iTrader: (4)

Ok so i have the gear in my possesion its from a spec d hawkeye and i will need to use all four 06 shafts? Or do i can i use my rears? The 06 shafts are they the correct length? I wanna start this tomorrow so if someone can get back asap

banny sti

iTrader: (68)

The 06 car will be wide track, so the shafts maybe slightly different so just re use your own

chris_wrx

iTrader: (4)

What about the stub axles?

T4YLOR 83

iTrader: (2)

Just use the whole setup from the spec d mate as it's all newer and will all fit that gearbox, diff, prop, and driveshafts :-)

chris_wrx

iTrader: (4)

What about drive shaft length?