desd77

hello i have an sigma m30 alarm in my 98 V5 wagon could any one please tell me is there any way to wire an apexi turbo timer up to my alarm cause at the moment i have to wait till the timer runs out before i can arm the alarm
thanks for any and all help
Des D

Mrchips

iTrader: (7)

Look in the search, as someone has asked this one before.

P600wrx

iTrader: (1)

yeah it's simple,

what you need to do is remove the fuel cut and move the ignition input to the ignition feed by the key, then between the ignition input and the turbo timer ignition wire fit a diode, u need to cut your main ignition wire for this, the diode will then stop the turbo timers ignition feed to the alarm and allow you to arm the car while the timer runs down, or just drive of boost for the last 2 mile of your journey and all will be well, as cold air moving over the engine will cool things down better than driving hard and then parking up for all the heat to not go anywhere.....

desd77

thanks for they help lads
p600wrx by any chance u wouldn't have a wiring diagram to that
i was kinda hopen it would have been easier than that
was kinking of using the auto arm on a time delay but that didn't work ether

thanks for all the help lads