anyone have on of these to fit a ninja back box ? or is it that easy lol

 

Its that easy. Not just for a ninja, for any back box.
It'll be self explanitory when you get under there.

 

ok great cheers

 

Dead easy,remove 2 x bolts,replace gasket if you need to,wd40 on the rubbers and they slide straight off,backbox is off.. I never even bothered jacking my car up when i fitted the ninja 2 to my classic

 

better to buy a gasket and bolt kit from scoobyworld , its only 7 quid.

just fitted a afterburner vortex to mine and i had to burn the bolts off they were that rotten.

 

cheers midnight ,you did well without jacking it up lol, grant thats what im worriede about rotten nuts how did u burn them off? im gonna do it on my drive with ramps tomorrow me thinks

 

best to have a good look at the flange from under the car, and youll be able to judge how rusty/rotten the 2 bolts are .

maybe even give them a wire brush and soak with wd 40 the night before you are planning to fit the backbox.

if they look really rusty, and you dont have the facilities, ie : ramp and oxy acetalene to burn them off, then phone about the local garages and see if one can fit it for you, although they might be a bit reluctant to do it as youre supplying the exhaust, but if you phone a few then one should do it for you.

however the gasket kit from scoobyworld is a wise buy before you touch it, and its cheap.

good luck with fitting

 

thanks grant i could nt do it so off to ring round the garages dam it!