fmic advice
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Aug 2009
Location: ukscoobies.com
Posts: 597
Likes: 0
Received 0 Likes
on
0 Posts
fmic advice
What small mods would i need to do to a fmic off a my99 uk turbo so it will fit my 1995 wrx import ??
cheers
Bry
www.ukscoobies.com
cheers
Bry
www.ukscoobies.com
#3
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Aug 2009
Location: ukscoobies.com
Posts: 597
Likes: 0
Received 0 Likes
on
0 Posts
yes i need one and want one. My top mount is no good for more than 290bhp and by the time you mess about with a sti top mount you have the problem of heat soak ect and end up with the same amount of money spent as a fmic you might as well have the fmic. So back to the original question will i get away with out moving the ac unit if i cut the pipe and make a silicon joint??
#4
yes i need one and want one. My top mount is no good for more than 290bhp and by the time you mess about with a sti top mount you have the problem of heat soak ect and end up with the same amount of money spent as a fmic you might as well have the fmic. So back to the original question will i get away with out moving the ac unit if i cut the pipe and make a silicon joint??
#5
Scooby Regular
iTrader: (1)
Join Date: Mar 2009
Location: southampton
Posts: 1,589
Likes: 0
Received 0 Likes
on
0 Posts
ii fitted a hrybird fmic kit which harvey sith does on my wrx version 4 and did not need to cut any pipes just a bit of the bumper and bit of the front suport bar and a little bit out of the inner wing job done but it does take a a good few hours of tit arsing around
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM