A pillar pod
#1
Scooby Regular
Thread Starter
Join Date: Jan 2010
Location: Glasgow
Posts: 313
Likes: 0
Received 0 Likes
on
0 Posts
A pillar pod
Ive just purchased an A pillar pod and gauges and was wondering the best way to run the cables to get a switched supply from the dash lights,do i have to remove the dash or should the bottom of the steering column be enough to let me pass the cables down to get a feed?
I also need to run the cables and hoses etc thro to the engine bay but there is a grommit in the drivers footwell i plan to use for this,so i would need to get from the A pillar to here to.
Thanks in advance
MY00 WRX STi
I also need to run the cables and hoses etc thro to the engine bay but there is a grommit in the drivers footwell i plan to use for this,so i would need to get from the A pillar to here to.
Thanks in advance
MY00 WRX STi
Last edited by gordy07; 08 October 2010 at 11:21 PM.
#4
Scooby Regular
iTrader: (4)
Join Date: Sep 2007
Location: JDM MY97 Type R - 2.1 Stroker
Posts: 1,008
Likes: 0
Received 0 Likes
on
0 Posts
Never really looked for a switched illumination feed in the dash so I can help you any further mate, but there is bound to be one on there.
You will certainly find one on one of the stalks.
You will certainly find one on one of the stalks.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM