Hi to all MY98
Currently running an Apexi Power FC with 440cc Injectors,larger TMIC,etc.My question is with regards to install of 740cc injectors/FMIC,cone filter,fuelab pressure regulator with the Apexi pfc,what values are needed for purposes of adjustment,also what pressure would the fpr require?Reason for asking this is due to ecu upgrade,mafless and the need to drive for ecu fitting/mapping.Many thanks in advance

 

740s I believe can do 500+ bhp at normal 3bar pressure, so unless you fit a 500+ turbo, then you have more than enough fuelling... with or without the help of an adj. FPR.

What turbo do you intend to fit?

 

Hi Joz.Turbo to be fitted will be a gt30/35.As said,its fuelling that concerns me with the 740's as require travel for installation/mapping of new ecu

 

Ah, that is a 500+ turbo isn't it?

But you can roughly scale them on the Commander, if the PFC is pre-fitted, and there's a suitable base map on it. This might be able to make the car drivable to get to the mapper - off boost obviously.

Alternatively, you could make this not an issue, by getting JGM or dynamix to come to YOU to map the whole shebang...