CV joint in 1/2 inch box section?
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Dec 2005
Posts: 786
Likes: 0
Received 0 Likes
on
0 Posts
CV joint in 1/2 inch box section?
I need to put a couple of CV joints in some 1/2 inch box section (like you might find in a steering column) and mount a section along a bulk head on some kind of bearing / mount combination
This isn't for a car and can be quick, cheap and dirty - it's only for operating a levelling jack at low torque and rpm.
Any ideas what I could use? This is a cost sensitive little project! Any photos or links would be appreciated.
Thanks in advance.
This isn't for a car and can be quick, cheap and dirty - it's only for operating a levelling jack at low torque and rpm.
Any ideas what I could use? This is a cost sensitive little project! Any photos or links would be appreciated.
Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM