dabow

iTrader: (19)

well im almost there know, but trying to fit the water cross section
theres a breather there what wasnt there on the old one.

the cross section runs right along it. so took it out
what i need to know, where can i get a bung from to insert
theres no threads, need to do this before i can carry on

its a sti v7 block, but fitting in my early classic

any ideas
if you have what i need, pm me asap
so i can collect

ZEN Performance

You can pull the hose barb out the block and plug with an interferance fit bung turned up in alumiunium. That way you can use your existing water cross pipe. That or get a later cross pipe, but the feed to the heater matrix is different unless you go for an 06-> pipe in which case the rad hose outlet changes!

mcvicar

As said, just go into your local car parts place and ask for core plugs. Make a little template or measure the hole if you have a guage and fit the core plug. 2 min job fella.

dabow

iTrader: (19)

thanks for that.

all sorted know, just an issue wit hthe power steering pump know
thats a different thread