car wont start
#1
Scooby Regular
Thread Starter
Join Date: Oct 2005
Location: Scarborough
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
car wont start
changed my fuel pump as the car died for a walbro just fitted it but the car still wont start, can i take a live from the connector under the dash to the pump to see if its working ?? Cud it poss be the relay if so where abouts can i get one ??
#3
Scooby Regular
iTrader: (1)
have you a volt meter, if so test at the pump itself, to see if your getting 12v connect both the meters wire's to the pump after you have removed it of course and then give it a crank you should get a prime first before you crank it, if not the relay is up on the right hand side of the car, it's brown, you can run an ignition live to the pump but it means it will always be on with the ignition and not prime to start with,
as other post check crank sensor wire also
as other post check crank sensor wire also
#4
when you turn on IGN ,can you hear the pump priming, if not it could be the
connecter under the rear seat, sometimes they get corroded. happend to me.
if you had the pump out of the tank, are you sure you put the pipes on right when refitting, turn on IGN, if pump primes,turn IGN off agian, go to your engine, the pipe coming from fuel filter to engine, prize it of slowly, there should be pressure sqirting out fuel , if not you have mixed up the 2 larger hoses at the pump ,,,,worth a try
connecter under the rear seat, sometimes they get corroded. happend to me.
if you had the pump out of the tank, are you sure you put the pipes on right when refitting, turn on IGN, if pump primes,turn IGN off agian, go to your engine, the pipe coming from fuel filter to engine, prize it of slowly, there should be pressure sqirting out fuel , if not you have mixed up the 2 larger hoses at the pump ,,,,worth a try
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM