What would you expect from these mod's?
#1
What would you expect from these mod's?
Fully rebuilt original engine, fully documented. New crank, rod and pistons (standard), slight overbore, rebuilt heads.
Ported exhaust manifold
Wrapped manifold to turbo up-pipe, new
VF30 Turbo
Bell mouth decat front pipe, wrapped
Lightened flywheel
Decat centre pipe
Magnex back box, 3” tailpipe
Sytec uprated fuel pump
ECUTek remap on original ecu
It's 1999 UK Turbo.
Ported exhaust manifold
Wrapped manifold to turbo up-pipe, new
VF30 Turbo
Bell mouth decat front pipe, wrapped
Lightened flywheel
Decat centre pipe
Magnex back box, 3” tailpipe
Sytec uprated fuel pump
ECUTek remap on original ecu
It's 1999 UK Turbo.
Last edited by dan83590; 10 February 2010 at 08:40 PM.
#3
Standard intercooler and air box with panel filter.
It's are car I'm Mmmming and Ahhing over. It's printout is around 260/260. I thought this looked very low?
Do you think there is something hiding?
It's are car I'm Mmmming and Ahhing over. It's printout is around 260/260. I thought this looked very low?
Do you think there is something hiding?
#6
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
agreed.. standard 215ish..
is the print out from when it had the old turbo on?
I presume it is mapped for the new setup?
they do vary.. but would hope to see 300 from that setup.
Simon
is the print out from when it had the old turbo on?
I presume it is mapped for the new setup?
they do vary.. but would hope to see 300 from that setup.
Simon
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM