boost t pipe heat damage
#1
Scooby Regular
Thread Starter
iTrader: (7)
Join Date: Jun 2009
Location: edinburgh
Posts: 655
Likes: 0
Received 0 Likes
on
0 Posts
boost t pipe heat damage
just to say that today i tried to sort out the boost on the v3 and found that some pipes bend into a 90* angle and basically close themeselves due to the heat hence u start to overboost and the thud comes lol ( fuel cut ) so be aware not to use certain hoses for doing this
also to ask if anybody had ever encountered this before ?
also to ask if anybody had ever encountered this before ?
#2
Scooby Regular
Thread Starter
iTrader: (7)
Join Date: Jun 2009
Location: edinburgh
Posts: 655
Likes: 0
Received 0 Likes
on
0 Posts
this happens were the nipple on the housing faces upwards and the actuator faces to the right , if the pipe is too long then basically the heat can cause certain pipes i noticed to form a sharp bend just after where the pill goes
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM