boost solenoid/dump valve
#1
Scooby Regular
Thread Starter
iTrader: (13)
Join Date: Oct 2009
Location: here, there, everywhere
Posts: 3,111
Likes: 0
Received 0 Likes
on
0 Posts
boost solenoid/dump valve
had to make a bespoke induction piping after fitting my fmic
i have an early classic sti and the resonator box fouls the pipe work, so..
i need to fit an adaptor to the piework to pipe to the boost solenoid,
can i just use the washer jet hose for this, im not sure if the pipe will be ok? it will only feed a slight vacum as its post maf- pre-turbo.
q2. fitted an hks dump valve, replacing the baileys one i had (basically because the adaptor on the fmic piping wouldnt fit the baileys) so now it wont be recirculating - take it i just blank off the origional pipe to the inlet manifold?
or there is a nipple at the top of the dump valve, is that to join to the inlet manifold? sorry ive got no/little exp in dumpvalves
thanks for any input
i have an early classic sti and the resonator box fouls the pipe work, so..
i need to fit an adaptor to the piework to pipe to the boost solenoid,
can i just use the washer jet hose for this, im not sure if the pipe will be ok? it will only feed a slight vacum as its post maf- pre-turbo.
q2. fitted an hks dump valve, replacing the baileys one i had (basically because the adaptor on the fmic piping wouldnt fit the baileys) so now it wont be recirculating - take it i just blank off the origional pipe to the inlet manifold?
or there is a nipple at the top of the dump valve, is that to join to the inlet manifold? sorry ive got no/little exp in dumpvalves
thanks for any input
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM