idle control valve help
25 October 2009, 03:39 PM
#1
Scooby Regular
Thread Starter
iTrader: (38)
Join Date: Sep 2009
Location: oxfordshire
Posts: 749
Likes: 0
Received 0 Likes
on
0 Posts
idle control valve help
hi ive got a 96 wrx with an engine check light coming up 2 4 idle control valve.got replacements knocking about in garage to replace but does the valve need setting up
or adjusting side to side as the fitting holes seem like adjuster slots.thanks in advance for any help given.pete
or adjusting side to side as the fitting holes seem like adjuster slots.thanks in advance for any help given.pete
25 October 2009, 04:09 PM
#2
Scooby Regular
iTrader: (21)
Join Date: Jan 2009
Location: oxfordshire
Posts: 1,006
Likes: 0
Received 0 Likes
on
0 Posts
take the whole thing off..
and give it a good clean out,theres three 10mm bolts that hold it on the inlet.!
undo them get some brake/clutch cleaner in a spray can,and go mad with it,then get a rag and give it a wipe down...
just one thing the pipes that are joined onto it are coolant hoses....
so dont remove them..
and give it a good clean out,theres three 10mm bolts that hold it on the inlet.!
undo them get some brake/clutch cleaner in a spray can,and go mad with it,then get a rag and give it a wipe down...
just one thing the pipes that are joined onto it are coolant hoses....
so dont remove them..
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
supshon
General Technical
2
03 October 2015 08:06 PM