AVCR Settings Help needed please.
#1
Scooby Regular
Thread Starter
iTrader: (21)
Join Date: Jul 2005
Location: North West
Posts: 1,236
Likes: 0
Received 0 Likes
on
0 Posts
AVCR Settings Help needed please.
Can someone please assist me in tweaking and setting up my AVCR correctly for optimum use, the Apexi instructions are double dutch to me?
Many thanks
Many thanks
#2
Scooby Regular
iTrader: (1)
Join Date: Jun 2009
Location: South Wales
Posts: 1,388
Likes: 0
Received 0 Likes
on
0 Posts
My mates got one so I could maybe see if he has a clue but I don't have any experience with these. Found this, an installation guide with some info for setting up on page 3;
Installing APEXi AVCR - Page 3
Don't know if that'll help you but worth a try. Goodluck
Installing APEXi AVCR - Page 3
Don't know if that'll help you but worth a try. Goodluck
#4
Scooby Regular
Thread Starter
iTrader: (21)
Join Date: Jul 2005
Location: North West
Posts: 1,236
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
Running an MD321T on JDM STi standard internals, APS 3.5" full system. GT spec Headers, APS Induction Kit, 650cc injectors & Walbro, Hyperflow TMIC, running 430HP / 361Lbs. Had my mapper set the AVCR up but had boost cut / creep problems recently, just dont know how to get the best out of the unit. Dont want to take it over 1.5 Bar so need to know how to set the duty & cycle up properly.
Cheers
Running an MD321T on JDM STi standard internals, APS 3.5" full system. GT spec Headers, APS Induction Kit, 650cc injectors & Walbro, Hyperflow TMIC, running 430HP / 361Lbs. Had my mapper set the AVCR up but had boost cut / creep problems recently, just dont know how to get the best out of the unit. Dont want to take it over 1.5 Bar so need to know how to set the duty & cycle up properly.
Cheers
Last edited by KK3960; 04 October 2009 at 06:30 PM.
#5
kk wkd man , erm what u gotta do is go on to the settings when u can adjust the boost pressure and duty of what the avcr is set at , take it down 5 each time and give it some , once you reach the point where your fuel cut is not cuting in u are runing optimun safe boost
#6
Scooby Regular
Join Date: Jul 2005
Location: Running gt3542 rotated and loving the POWER!!!!!!!
Posts: 480
Likes: 0
Received 0 Likes
on
0 Posts
Hi Kris have a word with Edmy he's done a lot of work with the avcr, I will PM you his number if you want, let me know
Cheers Dougie
Cheers Dougie
Thread
Thread Starter
Forum
Replies
Last Post
robbie1988
Wanted
2
13 September 2015 09:25 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM