HELP new fan shroud
24 September 2009, 04:15 PM
#1
Scooby Regular
Thread Starter
Join Date: Feb 2009
Location: Berkshire
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
HELP new fan shroud
Hi,
I have a UK 97 turbo impreza now with a new fan shroud I am trying to install. Trouble is the harness has 3 wires ground, hi and low for different speeds where the new one one has 2 wires ground and on I believe.
How should I wire this in. If I bridge with a loop of wire across the hi and low lines will I cause any damage.
I have a UK 97 turbo impreza now with a new fan shroud I am trying to install. Trouble is the harness has 3 wires ground, hi and low for different speeds where the new one one has 2 wires ground and on I believe.
How should I wire this in. If I bridge with a loop of wire across the hi and low lines will I cause any damage.
02 November 2009, 10:12 PM
#6
Scooby Regular
Thread Starter
Join Date: Feb 2009
Location: Berkshire
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
I posted on here sometime ago for advice but after no reply I just bridged across the harness hoping that the fans would come on if needed if they received power from both high and low wires.
As it turns out, this seemed fine at first but then the right come on when the ignition is turned on and stayed on even after starting.
I have tried putting the original fans back on and they done the same. In test mode only the right was working. I also tried swapping the relays around and they appear to all be working but the outcome is the same.
A/C is out of service as it needs gas
What now
Can I put some kind of diode in to stop any feed back and perhaps damage
What are the high and low colours for each fan as you too have a UK car.
Please help I need these new fans working as they are the only ones that will fit my new radiator
As it turns out, this seemed fine at first but then the right come on when the ignition is turned on and stayed on even after starting.
I have tried putting the original fans back on and they done the same. In test mode only the right was working. I also tried swapping the relays around and they appear to all be working but the outcome is the same.
A/C is out of service as it needs gas
What now
Can I put some kind of diode in to stop any feed back and perhaps damage
What are the high and low colours for each fan as you too have a UK car.
Please help I need these new fans working as they are the only ones that will fit my new radiator
Last edited by CatalunyaSimon; 02 November 2009 at 10:14 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM