i thought id just add this if you need any other info about mods ect just check my other post

update

right this is how it is now,the car will boost totaly fine after a ecu reset but after a short while the car struggles to boost over 0.5,if i drive the car hard it will go above 0.5 bar but only if i push it hard above 5 and half to 6000 rpm this is not right,after the reset the dump valve sounds loud but after a while it just goes quite but again louder if i push it hard.

ami right in thinking its not in lim[p home mode if it goes above above 0.5 bar when im pushing it

i dont like to drive the car to hard so i just thought it was in limp home mode because i dont like to hammer it

steven

 

bttt

 

exactly the same problem as mine. fitted to electronic boost controller and did a open ecu remap and its now boosting fine. But boost remain stable at 1 bar. mine only boost stil 0.5 bar before from 1-3rd gear then up to 0.8 form 4th above.

 

could this not be a maff problem.