Coolant
#1
Scooby Regular
Thread Starter
Join Date: May 2006
Location: Tell em to piss off, I'm drinking!
Posts: 789
Likes: 0
Received 0 Likes
on
0 Posts
Coolant
I plan on doing a coolant flush.
How much coolant does the classic hold?
Does the radiator on classics have a bleed screw? If so where abouts?
How much coolant does the classic hold?
Does the radiator on classics have a bleed screw? If so where abouts?
#2
about 7.2litres of 50%water and 50%coolant.
it has a bleed screw but its not very good. its too high up to get all the water out. best off takeing to bottom hose off the rad side (can leave on engine block side). then leave it to drain for 20mins. it takes ages for it all to come out of the engine block.
then flush with water.
it has a bleed screw but its not very good. its too high up to get all the water out. best off takeing to bottom hose off the rad side (can leave on engine block side). then leave it to drain for 20mins. it takes ages for it all to come out of the engine block.
then flush with water.
#4
i just used water. all you need to do is get the bits of crap out,
it does take a while to flush cos you have to wait ages for it to all come out of the block. unless you remove the stat. then it will **** out.
it does take a while to flush cos you have to wait ages for it to all come out of the block. unless you remove the stat. then it will **** out.
#5
oh, p.s dont use the halfords pink stuff! its the wrong stuff as i found out! it is organic and caused a residue to form in my system, doh. i have no used comma blue stuff which is not organic and the problem has gone.
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM