Dead Scooby (please help)!!!
Disaster.
Started my Scooby to come back home from work and it cuts out. I then manage to start it again and rolled it down the hill and sort it would turn into life. No. Car cuts out again on the road so after starting again I pulled into a petrol station and it died again.
The car ignition turns and then you can rev it to around 1500rpm but it keeps dropping back down and then eventually cuts out and the ignition goes out. The battery light and engine management light stay on but thats it. You simply cannot rev it more than 1500 rpm.
Anybody any ideas of the top of their head? Its a 2005 blobeye WRX if that helps.





Started my Scooby to come back home from work and it cuts out. I then manage to start it again and rolled it down the hill and sort it would turn into life. No. Car cuts out again on the road so after starting again I pulled into a petrol station and it died again.
The car ignition turns and then you can rev it to around 1500rpm but it keeps dropping back down and then eventually cuts out and the ignition goes out. The battery light and engine management light stay on but thats it. You simply cannot rev it more than 1500 rpm.
Anybody any ideas of the top of their head? Its a 2005 blobeye WRX if that helps.






hi mine was doing the same when i blew a boost pipe off. to start it i would have to have someone block the hole.
or off my head it could be the fuel pump or lines
you tried scoobytek
or off my head it could be the fuel pump or lines
you tried scoobytek
Disconnect the battery to reset the ECU.
If after a reset it runs ok then.... ok
If the CEL light stays on or the problem continues and there are no obvious loose hoses then get to a dealer/specialist and onto a diagnostics computer.
If after a reset it runs ok then.... ok
If the CEL light stays on or the problem continues and there are no obvious loose hoses then get to a dealer/specialist and onto a diagnostics computer.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM



Wish I could help mate, have you had anyone look at it yet?
